Tile Adhesive Application Process and Precautions

Ceramic tile glue use process and precautions

Ceramic tile glue is better than traditional materials in terms of use and performance, so many businesses and users will use it when decorating. The following Foshan Puhui New Materials Co., Ltd. will introduce its use process and precautions.

Generally speaking, there is little difference in the construction methods of tile glue. After using the adhesive, we can see how to use it according to the actual situation. Because the glue relay of this kind of glue is relatively strong, the thin paste method is generally used.

Use process and precautions

1, smooth the base

This is the premise of the whole paving work. The construction personnel should first clean and smooth the base, check whether there are empty drums and other problems, and then use a level to check the flatness of the wall, and the flatness of the base should be less than 3 mm every 2 meters. After preparing for this step, when we enter the next step, we must ensure that the tile paving is smooth and neat, and avoid the phenomenon of sticky distortion in the process of paving.

2,There are two coating methods for ceramic tile laying: base coating method and group method. The so-called bottom coating method refers to the material on the wall, the initial thin coating compacted, thick coating again; Use a tooth scraper (tooth scraper and the base into a 45-60 degree Angle of scraping) to apply the tile adhesive to the base, so that it is evenly distributed to form a full tooth. The combination rule is specifically for large and heavy bricks, and is also recommended when the back groove is deep. On the basis of the basic coating method, the tile adhesive is glued to the back of the tile and compacted.

3, pay attention to the difference between the wall and the ground when installing the cross: the size of the wall tile seam is generally about 1-1.5mm, the special gap needs to be accelerated, such as antique bricks, etc., the joint size of the floor tile is generally about 1.5-2mm, the gap of the floor tile is generally not recommended to be too large, easy to accumulate dirt and affect cleaning; Once the brick surface is cleaned, the paving work is complete.

In addition, Foshan Puhui New Materials Co., Ltd. reminds you that when paving, residents can use a single tile glue to lay, you can also use tile glue + water-based tile glue to lay, stronger adhesion, prevent empty bricks from falling off, and solve worries. It can also be handed over to a professional decoration master to use tile glue to ensure that the function of tile glue is fully played.